2-90
SERVICING
(2.6 Wall Type)
Phillips ScrewdriverTool
TURN OFF all power source switches.
2.6.9 Removing Fan and Fan Motor
(1) Remove the heat exchanger according to the item 2.6.5 “Removing Heat Exchanger”.
(2) Remove the supporting plate for the bearing by pushing the knobs at both sides of the supporting
plate toward the inside and releasing the catches.
Phillips ScrewdriverTool
(3) Remove the motor holders 1 and 2 fixing the fan motor.
For removing the motor holder, insert the screwdriver at the catch part and screw it.
(4) After removing the motor holder 1, loosen one (1) screw fixing the motor shaft and the fan.
Push levers on both sides to release catches.
Bearing (inside)
Supporting Plate
Lever
Catch
Motor Holder 2
Fan Motor
Motor Holder 1
Screwdriver
Catch
Motor Holder 1,2
To Next Page
Loading...
