6-28 ●Long-term Shutdown
Remove the tube connection block of ink reservoir and clean the end of the
tube with makeup.
1
Tube connection block
Beaker
Remove the cap of the ink reservoir. Drain the remaining ink and clean inside
the ink reservoir with makeup.
2
Ink reservoir
Cap
Pour 50 ml of makeup into the Ink reservoir.
● Pour 50ml makeup into the Ink reservoir so that the end of the tube connection block contacts the
makeup surface. This will prevent the tube connecting block from ink fixing.
3
Place the cap and tube connection block as they were, and place the ink
reservoir back in place.
● Be careful not to break the tube when mounting it into the printer.
4
To Next Page
Loading...
