Hitachi SJ Series - Page 47

Procedures:
(1)
(2)
Chapter 6
For the use of
duty (LD)/very low duty (VLD), follow the
installation procedures shown in the figure
below.
Procedures:
(1)
Remove four truss head screws that
and lower) brackets provided by factory configuration.
(2)
Change the position of the screw holes for the (upper
and lower) brackets.
◆
Notes for P1
Step (4)
Screws prepared on your own
Chapter 6
For the use of
P1
duty (LD)/very low duty (VLD), follow the
installation procedures shown in the figure
below.
Remove four truss head screws that
and lower) brackets provided by factory configuration.
Change the position of the screw holes for the (upper
and lower) brackets.
Notes for P1
-
00600
Figure How to install
Step (1)
Screws prepared on your own
Screws prepared on your own
P1
-00600-L
(P1
duty (LD)/very low duty (VLD), follow the
installation procedures shown in the figure
Remove four truss head screws that
hold the (upper
and lower) brackets provided by factory configuration.
Change the position of the screw holes for the (upper
00600
-L (P1-
110L)
Figure How to install
Screws prepared on your own
Screws prepared on your own
Screws prepared on your own
(P1
-
110L) at low
duty (LD)/very low duty (VLD), follow the
installation procedures shown in the figure
hold the (upper
and lower) brackets provided by factory configuration.
Change the position of the screw holes for the (upper
110L)
Truss head screw
Step
(2)
Step (3)
Step
Step (4)
Screws prepared on your own
Screws prepared on your own
6-8
110L) at low
installation procedures shown in the figure
Change [Ub
LD, respectively.
hold the (upper
and lower) brackets provided by factory configuration.
Change the position of the screw holes for the (upper
(3)
(4)
Truss head screw
(2)
Step
(3)
Screws prepared on your own
Change [Ub
-
03] to 00 and [Ub
LD, respectively.
Tighten the (upper and lower) brackets using four truss
head screws removed in
(Tightening torq
Install P1-
00600
screws prepared on your own.
Figure Front and right side diagrams
03] to 00 and [Ub
LD, respectively.
Tighten the (upper and lower) brackets using four truss
head screws removed in
(1).
(Tightening torq
ue 2.2 to 2.5 Nm)
00600
-L (P1-
110L) on the wall using four
screws prepared on your own.
Wall
Figure Front and right side diagrams
Installation
03] to 00 and [Ub
-
03] to 01 to set VLD and
Tighten the (upper and lower) brackets using four truss
(1).
ue 2.2 to 2.5 Nm)
110L) on the wall using four
screws prepared on your own.
Wall
Wall
Figure Front and right side diagrams
Installation
03] to 01 to set VLD and
Tighten the (upper and lower) brackets using four truss
110L) on the wall using four
Wall
Figure Front and right side diagrams
Installation
Tighten the (upper and lower) brackets using four truss