7.3 Use the Backing Plate
1. When a conduit tube is not connected
2. When a conduit tube is connected
7.3 Use the Backing Plate
connecting wires to apply high voltage on the
AL terminal, draw out the plate separately from the
wiring of control circuit.
Cut the connections between the unnecessary part
and backing plate using nippers, radio pliers, or
cutter, to cut off the unnecessary part for wiring.
1. When a conduit tube is not connected
Cut the rubber bushing to create a notch using
nippers or a cutter for wiring.
2. When a conduit tube is connected
Remove the rubber bushing in the portion where
a conduit tube is to be connected, a
connect the conduit tube.
Do not remove rubber busings from
the wiring section unless a conduit
cause the edge of backing plate to
damage the cable sheath, leading to
7.3 Use the Backing Plate
connecting wires to apply high voltage on the
AL terminal, draw out the plate separately from the
wiring of control circuit.
Cut the connections between the unnecessary part
and backing plate using nippers, radio pliers, or
cutter, to cut off the unnecessary part for wiring.
1. When a conduit tube is not connected
Cut the rubber bushing to create a notch using
nippers or a cutter for wiring.
2. When a conduit tube is connected
Remove the rubber bushing in the portion where
a conduit tube is to be connected, a
connect the conduit tube.
Do not remove rubber busings from
the wiring section unless a conduit
cause the edge of backing plate to
damage the cable sheath, leading to
7.3 Use the Backing Plate
connecting wires to apply high voltage on the
AL terminal, draw out the plate separately from the
wiring of control circuit.
Cut the connections between the unnecessary part
and backing plate using nippers, radio pliers, or
cutter, to cut off the unnecessary part for wiring.
1. When a conduit tube is not connected
Cut the rubber bushing to create a notch using
nippers or a cutter for wiring.
2. When a conduit tube is connected
Remove the rubber bushing in the portion where
a conduit tube is to be connected, a
connect the conduit tube.
Do not remove rubber busings from
the wiring section unless a conduit
cause the edge of backing plate to
damage the cable sheath, leading to
connecting wires to apply high voltage on the
AL terminal, draw out the plate separately from the
Cut the connections between the unnecessary part
and backing plate using nippers, radio pliers, or
cutter, to cut off the unnecessary part for wiring.
1. When a conduit tube is not connected
Cut the rubber bushing to create a notch using
2. When a conduit tube is connected
Remove the rubber bushing in the portion where
a conduit tube is to be connected, a
Do not remove rubber busings from
the wiring section unless a conduit
cause the edge of backing plate to
damage the cable sheath, leading to
Wire Connection and Optional Devices
connecting wires to apply high voltage on the
AL terminal, draw out the plate separately from the
Cut the connections between the unnecessary part
and backing plate using nippers, radio pliers, or
cutter, to cut off the unnecessary part for wiring.
Cut the rubber bushing to create a notch using
Remove the rubber bushing in the portion where
Wire Connection and Optional Devices
Wiring of
control circuit
Please contact the sales officer of our
company for the latest information.
Wire Connection and Optional Devices
Please contact the sales officer of our
company for the latest information.
Wire Connection and Optional Devices
Please contact the sales officer of our
company for the latest information.
Wire Connection and Optional Devices
Please contact the sales officer of our
company for the latest information.
Wire Connection and Optional Devices
To Next Page
Loading...
