Hitachi UX Twin Nozzle - Page 237

5-21
② Heat the silicone rubber filled part by warm air of a drier (500W or equivalent) for 7 to 8
minutes and cure the surface.
[Caution]
Keep the drier 50 to 100mm away from the head or the warm air may deform the tube.
シリ コ ン 注入のコ ツ
ディ ス ペン サの保管
Nozzle
If left as-is after use, the silicone rubber hardens in the metal needle portion of the
dispenser. Plug it by using a clip and so on.
Clip
Storage of the dispenser
When injecting the silicone rubber into the dispenser, perform it as shown
below (to purge air).
Metal needle
Cylinder
Put the silicone rubber in
Place the needle on
the upside
Cylinder
Downside is NO Good.
Wait until the silicone rubber
comes down to the piston
Piston
Place the needle on
the upside
Push the piston as if to purge air
Tip of Silicone rubber injection
50 to 100mm
Drier