Hitachi UX2-D160W - Page 261

Chapter 11. Safe Clean Station
11-3
Chapter 11.
11.1. Setting Head Cleaning Mode
Set the head cleaning function mode on the [Safe clean station environment setup] screen.
This setting is applied for only [Head cleaning].
(It is not applied for [Gutter cleaning (S)] or [Nozzle backwash (S)].)
Press Setting on the [HOME] screen.
Press Safe clean station function on the [Setting (1/3)] screen.
Press Safe clean station environment setup on the [Safe clean station function] screen.
1
2
3
2
3