Hitachi UX2-D160W - Page 285

Chapter 12. When Warning or Fault Occurs
12-9
Chapter 12.
Fault message list (faults that do not stop the ink jet) (Continued)
Message
No.
Message
Message description
Solution
E-057
Excessive Format
Count
The number of format types (the order of
[Line], [Line spacing], and [Dot matrix])
of each column exceeds eight.
● Set eight or fewer format types.
E-062
Internal
Communication
Error C
An internal data processing error
occurred.
● Turn the power OFF and then back
ON after ten seconds.
E-063
Internal
Communication
Error M
An internal data processing error
occurred.
● Turn the power OFF and then back
ON after ten seconds.
E-232
Cleaning solvent
container sensor
non-detection error
The cleaning solvent container sensor
detected the OFF status.
● Drain the liquid in the cleaning
solvent container.
● Set the cleaning solvent container in
the cleaning station.
E-233
Printhead removal
error
No print head was found in the cleaning
head.
● Do not remove the print head from
the cleaning station during head
cleaning.
E-234
Air pump motor
error
The air pump is abnormal.
● Contact your nearest local
distributor.
E-240
Makeup Route
Pressure Is High
Makeup route pressure is high.
● Contact your nearest local
distributor.
E-245
Ink Level
Sensor Broken 1
The level sensor in the ink reservoir does
not work properly.
● Contact your nearest local
distributor.
E-246
Makeup Level
Sensor Broken 1
The level sensor in the makeup reservoir
does not work properly.
The mode is switched temporarily so that
the makeup cannot be replaced until the
warning [Makeup Low Warning]
appears.
● Contact your nearest local
distributor.
E-254
Ink Level
Sensor Broken 3
The level sensor in the ink reservoir does
not work properly.
● Contact your nearest local
distributor.
E-255
Makeup Level
Sensor Broken 3
The level sensor in the makeup reservoir
does not work properly.
● Contact your nearest local
distributor.