raidcom add journal
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
CMDRJE Executing 2EF3 5002 The specified parameter is invalid. Check the
Command Control Interface Command Reference.
CMDRJE Executing B980 B903 The command was rejected because the selected
resource belongs to NAS_Platform_System_RSG.
Table 9-22 SSB codes returned by raidcom modify journal
raidcom modify journal
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E00 0023 The specified volume capacity is too small.
CMDRJE Executing 2E00 500B The specified path block watch time is not in the
valid range.
CMDRJE Executing 2E00 8301 The specified MP Blade ID is invalid.
CMDRJE Executing 2E10 0011 The specified volume is not installed or cannot be
used.
CMDRJE Executing 2E10 5000 The specified operation failed because the journal
or mirror is not in the operable status.
CMDRJE Executing 2E10 5006 The specified operation failed because the mirror of
journal is not in the operable status.
CMDRJE Executing 2E10 8300 The specified MP Blade is blocked.
CMDRJE Executing 2E11 800B The operation cannot be performed because it is in
the state of start-up.
CMDRJE Executing 2E20 5000 The specified journal ID is not registered.
CMDRJE Executing 2E21 5000 The operation failed because the specified journal
is not registered.
CMDRJE Executing 2E21 8104 The journal volume cannot be added, or the
journal cannot be added to the extended
consistency group due to insufficient capacity of
the shared memory.
Get Command
Status
Async 2E30 0062 The specified volume cannot be used as a journal
volume because it is an external volume that can
execute the I/O suppression mode.
CMDRJE Executing 2E30 5001 The timer type cannot be changed because the
specified journal belongs to the extended
consistency group.
9-50
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
