Hitachi WJ200-001S - Restoring Factory Default Settings

90
Other indication
Error
Code
Name
Descriptions
Rotating
Reset
RS input is ON or STOP/RESET key is pressed.

Undervoltage
If input voltage is under the allowed level, inverter shuts
off output and waits with this indication.

Waiting to restart
This indication is displayed after tripping before
restarting.

Restricted operation
command
Commanded RUN direction is restricted in b035.

Trip history initializing
Trip history is being initialized.

No data
(Trip monitor)
No trip/waning data exists.
Blinking
Communication error
Communication between inverter and digital operator
fails.

Auto-tuning
completed
Auto-tuning is completed properly.

Auto-tuning error
Auto-tuning fails.
NOTE: Reset is not allowed in 10 second after trip.
NOTE: When error E08, E14 and E30 occur, reset operation by RS terminal or STOP/RESET key is
not accepted. In this case, reset by cycling power. If still same error occurs, perform initialization.
Restoring Factory Default Settings
You can restore all inverter parameters to the original factory (default) settings according to
area of use. After initializing the inverter, use the powerup test (please refer to Chapter 2 in
the Instruction Manual) to get the motor running again. If operation mode (std. or high
frequency) mode is changed, inverter must be initialized to activate new mode. To initialize
the inverter, follow the steps below.
(1) Select initialization mode in .
(2) If =,  or , select initialization target data in .
(3) If =,  or , select country code in .
(4) Set  in .
(5) The following display appears for a few seconds, and initialization is completed with
 displayed.
* Please change from" (Basic display)" to " (Full display)" in parameter
    (Function code display restriction), in case some parameters cannot be displayed.