12-12
SPECIFICATIONS
Bucket Types and Applications
ZX210LC-6
Bucket
Bucket Capacity
m
3
Bucket Width mm
(With side cutter)
Application
Front-End Attachment
ZX210LC-6
PCSA
(Heaped)
CECE
(Heaped)
2.42 m Arm 2.91 m Arm
Hoe Bucket
0.51 0.45 830
0.80 HD 0.7 1150
0.80 0.7 1140
0.91 0.8 1260
1.10 0.9 1440
1.20 1.0 1450
(Without side cutter)
−
Bucket reinforcement can
be welded in four places
upon customer’s request
0.80 0.7 1140
0.91 0.8 1260
Reinforced Hoe Bucket
HD Type (Transverse-
Type-Pin-Used Type)
0.80 0.7 1140
V-Type Bucket − 90 °
Excavating
V-trenches
Ripper Bucket 0.50
800
(Without side cutter)
−
One Point Ripper − −
−
Clamshell Bucket 0.60 Bucket width 940 Side ditching
Slope-Finishing Blade − 1800
Bank cutting finish
f
NOTE:
Symbols in the above table have the following meanings.
: General excavating
: Light duty excavating
: Rock digging
: Loading work
: Slope-finishing work
– : Not applicable (not warrantable)
Hoe bucket is applicable to the following types of work.
General excavating:
For digging and loading operation of sand, gravel, clay, ordinary earth and so on.
Light duty excavating:
For digging and loading operation of dry, loosened earth, sand, mud and so on.
Their bulk density shall be less than 1.60 t/m
3
as a standard.
Loading:
For loading operation of dry, loosened earth and sand.
Their bulk density shall be less than 1.10 t/m
3
as a standard.
Rock digging:
For digging/loading operation of mountain gravels, blasted rock, hard clay, soft rock and so on.
IMPORTANT: Using inapplicable buckets may cause serious damage to the front structure such as boom, arm and
hydraulic cylinders.
To Next Page
Loading...
Need help?
General
