OPERATING THE ENGINE
3-4
NOTE: When maintenance information display is ON with
maintenance setting, the scheduled maintenance
screen for the item whose change interval has expired
displays for three to ten seconds. Then, the basic screen
displays.
7. The basic screen will be displayed on the monitor. Check
that the preheat indicator (4) is OFF at this time.
8. Turn key switch (2) to start engine.
IMPORTANT: Prevent starter damage.
Never operate starter motor for more than
10 seconds at a time. If engine fails to start,
return key switch to OFF. Wait for more than
30 seconds, then try again. After a false
start, do not turn key switch until engine
stops or starter may be damaged.
9. Release key switch (2) immediately after the engine has
started. It will return to ON position.
NOTE: For a while after the engine starts, the automatic heat-
ing system operates so that even though the engine
control dial is set in the slow idle position, the engine
speed will temporarily increase.
M1U1-03-001
Basic Screen
4
T1V5-05-01-170
To Next Page
Loading...
Need help?
General
