Assembly
27
Assembly instructions
Linear Guideways
GW-04-0-EN-1910-MA
X Press down the cover strip fold that has not been widened on the reference side of the profile rail.
X Press down the second fold on the opposite side.
The cover strip is resting flush on the upper side of the profile rail.
D. Assembly
X Clean the profile rail using a suitable cleaning agent (see Section 7.1).
X Position the block at the end of the profile rail.
X Push the cover strip on to the profile rail with one hand. The widened pushing area must be pushed under the block at
this point.
X Use your other hand to hold up the area of the cover strip that has not been widened.
The distance L
S
must be maintained in accordance with Table 5.2.
Repeat the steps in B if it is still not possible to push the cover strip on to the profile rail.
Ensure that the strip does not snap.
Fig. 5.32 Pushing on the cover strip with a mounted block
Fig. 5.33 Assembly of the cover strip
Fig. 5.34 Correctly and incorrectly installed cover strip
C. Checking the pushing area
X Place the cover strip at the beginning of the profile rail.
X Push the cover strip slightly on to the profile rail.
X Center the cover strip on the profile rail.
To Next Page
Loading...