Página 17
- 17 -
• Keep it away from heat, direct sunlight, humidity and cutting
tools. Do not under any circumstances immerse in water or
use this device with wet hands. In the case of humidity or
water in the device, immediately disconnect the power supply
and do not touch the wet parts.
• Do not attempt to service the device yourself. Contact a
qualified technician.
• To disconnect the convector from the mains, pull the plug,
never of the supply cord.
• Respect the "SPECIFIC SAFETY INSTRUCTIONS FOR THIS
APPLIANCE" listed below
SPECIFIC SAFETY INSTRUCTIONS FOR THIS DEVICE
• The appliance must remain in a vertical position.
• Make sure the appliance is secured at all times. Please adhere
to the installation distances indicated in this guide.
• Do not hang any object in front or on top of the device.
• Always ensure that the inlet and outlet air are not obstructed.
• Always install the device so that it cannot enter into contact
with any combustible material such as curtains or towels (take
into account the gusts of wind).
• To clean the device, consult the instructions in the
"MAINTENANCE" section, because if water enters the air
grilles it could seriously damage the device.
• Do not insert any object through the grille or inside the device.
• This convector is designed to be connected by plug to the
electric installation. Follow the instructions in
"INSTALLATION".
• Install the base as shown on the below drawing
To Next Page
Loading...