HK Audio LUCAS NANO 602 User Manual

LUCAS NANO 602 1.0
8
3.1 Mono System
with S-CONNECT POLE LN
No cables needed
S-Connect Pole LN
3.2 Mono System
with MONO STAND ADD-ON
Mono Stand Add-on Stereo Stand Add-on
3.3 Stereo System
with STEREO STAND ADD-ON
(also works with microphone stands)
Pole Mount
Adapter
M20
Adapter
3/8"
= 35 mm
Two speaker
cables needed
One
speaker
cable
needed
Signal via
Easy-Click
Bold black:
Part of the listed
accessories
3 Setups and Accessories
You can deploy LUCAS NANO 602 in various confi gurations. The optional
HK Audio accessories listed in section 3.7 let you do this with the greatest
fl exibility and convenience.
3.1 Mono System
With the S-CONNECT POLE LN
(see the picture below)
No speaker cables
Setup
LR
Balance
Screw the S-CONNECT POLE LN into the M33 pole mount on the
subwoofer’s top panel. Then attach the satellite array to the S-CONNECT
POLE LN adapter sleeve via the Easy-Click connector. The signal bus is built
in, so you don’t need to connect any speaker cables for this setup. Be sure
to set the Setup selector to ‘Satellite Array’ and the Balance knob to the
center or 12 o’clock position.
• Required accessories: S-CONNECT POLE LN
3.2 Mono System
With the LUCAS NANO 600 MONO STAND ADD-ON or in
combination with a standard 35 mm/M20 speaker extension pole
(see the picture below)
Use Speaker Out L
Setup
LR
Balance
Screw the included M33-to-M20 adapter sleeve into the pole mount on the
subwoofer’s top panel. Screw the speaker pole that comes with the MONO
STAND ADD-ON kit into the pole mount and attach the POLE MOUNT
ADAPTER included in the ADD-ON kit to the speaker pole’s top end. Then
attach the satellite array to the POLE MOUNT ADAPTER via the Easy-Click
connector.
Be advised that the POLE MOUNT ADAPTER does not route the signal
to the satellites; you will have to use a speaker cable to connect the
subwoofer’s Speaker Out L port to the satellite array.
Be sure to set the Setup selector to ‘Satellite Array’ and the Balance knob
to the center or 12 o’clock position.
• Required accessories: MONO STAND ADD-ON (1 two-piece speaker pole
with stand adapter, 1 speaker cord, 1 bag)
This setup option works with any standard 35 mm/M20 speaker extension
pole. All you need is the POLE MOUNT ADAPTER to attach the satellites.
3.3 Stereo System
With the LUCAS NANO 600 STEREO STAND ADD-ON or in
combination with standard microphone stands with a 3/8" thread
(see the picture below)
Use L/R Speaker Outs
Setup
LR
Balance
RL
Place the two LUCAS NANO 602 satellites on the STEREO STAND ADD-
ON speaker stands’ 3/8" threads and screw them down. Now connect the
satellites to the subwoofer’s two Speaker Outs using speaker cables. Be
sure to set the Setup selector to ‘Stereo Satellite’ and the Balance knob to
the center or 12 o’clock position.
• Required accessories: STEREO STAND ADD-ON (2 height-adjustable
speaker stands, 2 speaker cords, 1 bag)
This setup option works with any standard microphone stand, provided it
is fi tted with a 3/8" thread.

HK Audio LUCAS NANO 602 Specifications

General

Brand	HK Audio
Model	LUCAS NANO 602
Category	Stereo System
Language	English