Why Hkoenig HWP3 is not running?
Your Hkoenig Pressure Washer might not be running due to several reasons: it may not be plugged in (plug it in), the socket could be defective (try another socket), the extension cable might be faulty (try a different one), the mains voltage could be incorrect (check the voltage), the switch might be off (turn it on), or the fuse may have blown (replace the fuse).
What to do if Hkoenig HWP3 Pressure Washer does not reach operation pressure?
If your Hkoenig Pressure Washer isn't reaching operating pressure, it could be due to several reasons: * The spray lance may be blocked or worn (clean or change the spray lance). * There might be a short supply of water (check the inlet flow rate). * The hose could be kinked (straighten it out). * The filter might be blocked (clean the filter). * The hose could be blocked (clean the hose).
What to do if my Hkoenig HWP3 trigger gun can't be used?
If the trigger gun on your Hkoenig Pressure Washer can't be used, it's likely because the trigger gun is locked. Unlock the trigger gun safety to resolve this.
Why does my Hkoenig Pressure Washer have fluctuating pressure?
Fluctuating pressure in your Hkoenig Pressure Washer can be caused by a blocked spray lance (clean it with a needle), the pump sucking air (check that hoses and connections are airtight), or impurities in the pump. If impurities are the cause, contact the dealer.
General| Brand | Hkoenig |
|---|---|
| Model | HWP3 |
| Category | Pressure Washer |
| Language | English |
To Next Page