Around 3 minutes, steam available light (8) will die out, it means the
appliance can be using the steam.
Obtain steam after pressing the steam button (3). Release the button
(3) and the steam flow stops.
This appliance is also able to generate steam in a vertical position and
can therefore be used to refresh fabrics easily with a jet of steam.
When you ending the ironing, press the switch button (7), cut down the
power, press the steam button (3) to release the residual steam in the
boiler (13)
NOTE: Continue to release steam for long time, when pump adds
water into boiler, soleplate will stop to release steam for short time,
almost 10secs.
DRYIRONING
Connect the appliance to the mains supply, press the switch button(7),
then select the desired temperature by turning the thermostat
knob(4).Wait until the iron heating indicator light (2) goes off, indicating
that the desired temperature has been reached.
For dry ironing it is not necessary to press the steam button (3).
FILLING THE TANK
Thanks to the self-filling function, there is no longer any need to stop
and wait while the boiler fills up again.
When the water in the boiler is at minimum level, the pump is
automatically activated which fills the boiler once again.
If you hear the loud feed-water sound when you ironing, it means there
is no water in the water tank (14). Press the switch button (7) and cut
down the power. After fill the water tank (14), then press the switch
To Next Page
Loading...
