76
SLEEP FEATURE
While listening to the radio or AUX source, press the SNOOZE/DIM/SLEEP button to
minutes. Once set, the unit will continue playing for the set length of time, then will
automatically turn off.
NOTE: The Sleep Station Plus does not turn off the MP3/AUX device.
PROJECTOR FUNCTION
TIME on any flat surface.
desired focus.
OUTSIDE TEMPERATURE SET UP
The Sleep Station Plus is equipped with an outside temperature sensor that transmits a
signal and shows the outside temperature on the display.
the Sleep Station Plus.
3. The Sleep Station Plus will automatically receive the signal and display the outside
temperature on the LCD screen.
USB CHARGING PORT
your device with a USB Type A connector on the other end.
CONNECTING 3.5MM AUDIO INPUT JACK
audio device.
3. Push power button on the unit, then push the source button and select AUX mode
5. When finished, press the power button to turn off the unit.
NOTE: You must turn OFF your audio device.
VOLUME CONTROL
DISPLAY DIMMER CONTROL
The power selector button needs to be off to use the dimmer control.
BACKUP BATTERY
MAINTENANCE
To Store: You may leave the unit on display, or you can store it in a cool, dry place.
To Clean: Use only a soft dry cloth to clean the enclosure of the unit.
NEVER use liquids or abrasive cleaner to clean.
FCC DISCLAIMER
NOTE
this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by HDMX could void the user's
authority to operate the equipment.