– 7 –
Set Mixing Time (Preset Keys P1 or P2)
Each preset key has four time settings. The indicator lights above the number 1, 2, 3 or 4 and the P1
or P2 indicator light identify which preset time is being displayed. The chart below shows the default
settings. The next page shows how to revise these preset times. The TIME Knob can be used to adjust
the mixing time if it is turned prior to pressing START.
Beginning from the idle display [-- :--], press P1 or P2 to display the #1 preset mixing
time. (Pressing P1 or P2 again will display the next preset time, etc.)
The TIME knob can adjust the time.
START and STOP buttons control mixing operation.
Press START to begin mixing. The timer will count down from the set time to [00 :
00].
If STOP is pressed, both mixing and timer countdown will be interrupted. After
pressing STOP, press START to resume both mixing and timer countdown; or press
CLEAR to return to the idle display.
When the mixer is stopped, you can perform the following tasks: add ingredients,
change speed, reset the timer, continue mixing or unload.
When the timer reaches [00 : 00], the mixer stops. A tone sounds for 2 seconds and
the next preset mixing time displays. When the last preset time reaches [00 : 00], the
P1 or P2 indicator light is lit and the idle display [-- : --] returns. Repeat from
to complete four preset times.
The timer reverts to the factory-programmed preset times after any power interruption.
FACTORY-PROGRAMMED PRESET TIMES
-
P1
-
P2
01:00
- - - -
1 2 3 4
Indicators above P1
and 1 indicate the
first preset time
contained in P1.
yeKteserP
rotacidnI
12 3 4
1P00:1000:2000:0100:00
2P00:2000:1000:5000:30
D340 Mixer Technical Manual Page 13 of 67
To Next Page
Loading...
Need help?
General
