Hobart MG1532 User Manual

701 S. RIDGE AVENUE
TROY, OHIO 45374-0001
937 332-3000
www.hobartcorp.com
FORM 34389 Rev. B (Aug. 2001)
MG1532 & MG2032 MIXER-GRINDERS
MODEL
MG1532 ML-134099 7.5 HP Grind Motor + 1 HP Mix Motor
MG1532 ML-134103 5 HP Grind Motor + 1 HP Mix Motor
MG1532 ML-134100 7.5 HP Grind Motor + 1 HP Mix Motor w/ Side Feed
MG2032 ML-134104 7.5 HP Grind Motor + 1 HP Mix Motor
MG2032 ML-134105 7.5 HP Grind Motor + 1 HP Mix Motor w/ Side Feed
Previous models covered by this manual:
MG1532 ML-104878 7.5 HP Grind Motor + 1 HP Mix Motor
MG1532 ML-104883 5 HP Grind Motor + 1 HP Mix Motor
MG1532 ML-104879 7.5 HP Grind Motor + 1 HP Mix Motor w/ Side Feed
MG2032 ML-104884 7.5 HP Grind Motor + 1 HP Mix Motor
MG2032 ML-104885 7.5 HP Grind Motor + 1 HP Mix Motor w/ Side Feed
MIXER-GRINDER

Hobart MG1532 Specifications

General

Brand	Hobart
Model	MG1532
Category	Grinder
Language	English

Summary

General Machine Overview

Installation Procedures

Caster and Leg Set Installation

Attaching caster assemblies or adjustable leg sets to the mixer-grinder base frame.

Machine Leveling Guide

Instructions for adjusting the mixer-grinder to be level side-to-side and front-to-back.

Initial Lubrication and Checks

Information on pre-installed oil and checking transmission oil levels.

Pneumatic Foot Switch Setup

Steps for installing the optional pneumatic foot switch accessory.

Electrical Connection and Safety

Electrical Data and Receptacle/Plug Guide

Table detailing voltage, phase, ampacity, and connector types for models.

Motor Rotation Verification

Procedure to ensure correct counterclockwise rotation of mix arm and worm.

Mixer-Grinder Operation

Control Panel Button Functions

Explanation of MIX START, STOP, MIX/GRIND START, and FOOT SWITCH operations.

Hopper Lid Interlock Mechanism

How the hopper lid safety interlock prevents machine operation.

Grinder Attachment and Grinding Process

Mixing Arm Removal and Reassembly

Steps for detaching and reattaching the mixing arm from the hopper.

Grinding Procedures (First and Second Cut)

Detailed instructions for performing first and second grinds, including mixing.

Cleaning Instructions

Maintenance and Service

Lubrication Requirements and Schedule

Information on motor bearings and periodic gear case lubrication.

Gear Case Lubrication (Mixing Arm)

Specific guidance for lubricating the mixing arm gear case.

Gear Case Lubrication (Worm)

Specific guidance for lubricating the worm gear case.

Service and Repair Information

Contact details for Hobart Service for repairs and adjustments.