6 | Anchor Strap Installation
Anchor Straps
The provided anchor straps not only keep the rod holders tethered to the boat,
but also prevent them from rotating if you are trolling. To install the anchor
straps:
8”
8”
Screw the padeyes into
the gunnels of your kayaks
approximately 8” fore and aft of
the molded in rod holder location.
1
If you have screw-in padeyes on your kayak near the rod holders, you can also
replace them with the provided XL padeyes. Remove the old padeye with a pair of
pliers and thread in the new XL padeye.
1a
To Next Page
Loading...
Need help?
General