HOFFEN DJHS-H081 - Empty the drainage tank

To Next Page

To Previous Page

[56]

DEHUMIDIFIER

for a long time, remove the plug from the power supply and empty the

drainage tank (G).

Empty the drainage tank

• As soon as the drainage tank (G) is full, the full tank indicator (L) lights

up and a warning sound of 15 consecutive beeps sounds to alert the

user that it is necessary to empty the tank (G).

• Remove the tank (G) by gently pulling it with both hands through the

side recesses (g. 2) and pour all the water (g. 3). During this process

the full tank indicator (L) lights up red and ashes until the tank (G) is

replaced in the main body of the appliance.

• Re-assemble the tank (G) (g. 4) to resume operation. If the tank (G)

is not properly tted, the full tank indicator (L) is activated and the

appliance does not work.

 Note: Do not remove the oat (F) from the drainage tank (G) (Fig. 5). If

the oat is removed, the full tank sensor will not be able to detect the

water level correctly and water may leak from the tank (G).

Continuous drainage

• This appliance can be used in continuous drainage mode. For this

purpose, a PVC hose with an inner diameter of 10 mm (accessory

supplied with the appliance) must be used.

Fig. 2 Fig. 3

Fig. 5

Fig. 4