Commissioning 31
3.
Connect the mains cable to the power supply and its plug to a power socket.
Please note: Avoid placing the power supply unit and power supply cable in such
a way that one can trip over it and accidentally disconnects the device from the
power supply.
4. The device starts up and successively displays a welcome text, the device type, its
software version and the current number of therapy hours and then switches to
the date and time display (standby mode).
5. Connect the therapy tube to the mask.
6. Connect the unattached end of the tube to the air outlet.
If you are using a bacterial filter, fit it between the tube and air outlet.
7. Calibrate the device as described in the chapter „Calibration“ from page 62.
8.
Put the mask on. If automatic mode has been selected (see page 65), the device
is turned on by the patient‘s breathing. If automatic mode has been set to „OFF“,
the device is started by pressing the ON/OFF key.
9.
The device first of all runs (for the time selected by you for the mask test) at the
prescribed pressure. You should now ensure the mask‘s correct positioning to
avoid potential leakages.
To Next Page
Loading...
