6-27
Chapter 6
EMERGENCIES
Note If unsure of the bulb replacement process for any of the lamps, please have the
work carried out by a suitably trained service technician.
Notes when replacing bulbs
• Switch the ignition off and remove the keys.
• Switch off the related switch.
• It is important to t only bulbs of the specied wattage.
• Do not touch bulbs or reectors with bare hands. Greasy ngers cause stains
which evaporate, eventually resulting in a dull reector. Grease spots on Halogen
bulbs will, within a short time, lead to bulb failure. Clean stained bulbs with
methylated spirits.
•
Detailed procedures for headlamp aiming are given in the relevant service
manual for your vehicle. However, because headlamp aiming is a safety item it is
recommended that you have it carried out by your Holden Dealer.
Front lamps
To gain access to the front park bulbs, front turn signal bulbs, high, low beam and
front fog
3
bulbs:
1. Open the bonnet and remove the radiator cowl by unscrewing the 11 Phillips head
screws about 3 mm, then place a at-blade screwdriver under each of the ve
scrivets and gently pry them upwards. Remove the cowl.
BULB REPLACEMENT
CAPTIVA BOOK.indb 27 30/05/2007 12:49:50 PM
To Next Page
Loading...
