180 Vehicle care
Warning
The steel spare wheel is for
temporary use only. The vehicle
must not be driven at more than
80 km/h when this wheel is tted.
As soon as possible after
changing a wheel, have the
wheel nuts tightened with
a torque wrench to 140 Nm
(Newton metres) evenly in
the sequence shown (refer to
Step 23) as wheel nuts which
have not been tightened properly
could eventually allow the wheel
to come off while the vehicle is
moving.
Jump starting
Read the following warnings and
procedure in full before attempting to
jump start the vehicle.
If you are still unsure about
jump starting, Holden strongly
recommends for your safety and
that of the vehicle that you seek
the assistance of a suitably trained
service technician.
Warning
Do not push start or tow start
the vehicle. If unburnt fuel were
to reach the catalytic converter
and ignite, the converter could
overheat or be destroyed by
backre. Therefore, if the battery
is at, you can jump start, but do
not push start the vehicle.
To protect the vehicle’s electrical
system, never disconnect
the battery when the engine
is running. Never charge the
battery while it is still connected
to the vehicle. First disconnect
the negative cable, then the
positive cable. The polarity of the
battery, i.e. the connections for
the positive and negative cables,
must not be interchanged when
reconnecting. First connect the
positive cable, then the negative
cable.
BOOK_MY13_CAPTIVA 5.indb 180 1/03/2013 10:45:01 AM
To Next Page
Loading...
