106 Vehicle care
Load compartment lamp
1. Using a at-blade screwdriver,
prise the lamp assembly
outwards.
2. Remove the bulb.
3. Insert a new bulb.
4. Reinstall the lamp assembly
rmly into place.
5. Check lamp operation.
Electrical system
Fuses
Warning
Turn off the ignition (LOCK
position) and any electrical
equipment before changing
a fuse.
• Replace blown fuses promptly.
• A blown fuse can be recognised
by its melted wire.
• Do not replace the fuse until
the cause of the fault has been
remedied.
• Some functions are protected by
several fuses.
BOOK_MY12_BARINA_SPARK.indb 106 24/11/2011 1:11:14 PM
To Next Page
Loading...
