38 Seats, restraints
Where to put the restraint
Warning
Child restraint anchorages are
designed to withstand only those
loads imposed by correctly tted
child restraints. Under no
circumstances are they to
be used for adult seat belts,
harnesses, or for attaching
other items or equipment to
the vehicle.
Only child restraints that have
clips to attach to the vehicle’s
anchorage ttings are to be used.
Earlier types of child restraints
may not attach securely to this
type of anchor.
Use only Standards Australia
and New Zealand approved child
restraints and harnesses. Only
purchase a child restraint which
carries the appropriate Standards
Australia sticker of approval.
Where legally allowable, you
may install a forward-facing child
restraint in the front seat, but
always move the passengers
seat as far back as it will go.
The forward facing child restraint
must still be attached to the
passenger side child restraint
anchorage point, located behind
the rear seat.
Remember, it is safest for
children to be seated in the
rear seat.
Note
If unsure about installing a child
restraint, contact an approved
restraint tting station or a Holden
Dealer.
Top-tether child restraint
systems
The child restraint tether anchors
are located at the rear of the load
compartment in line with the three
rear seating positions.
Note
Use the child restraint anchors for
their designed purpose only.
BOOK_MY12_BARINA_SPARK.indb 38 24/11/2011 1:10:40 PM
To Next Page
Loading...
