Vehicle care 141
Warning
When the engine is hot, only
touch the foam padding of the
support rod.
3. Pull the support rod away from
the bonnet holder.
4. Rotate down and place into
the catch alongside the engine
compartment.
Closing
Warning
To avoid injury and/or damage
to the vehicle, check each time,
before the bonnet is closed, that
the contact area is unobstructed.
1. Place the support rod into the
bonnet holder.
2. Lower the bonnet and allow it to
drop into the catch.
3. Check that the bonnet is
engaged.
Warning
If while driving you notice that
the bonnet has not been properly
closed, pull the vehicle over to
the side of the road at the earliest
possible moment and close the
bonnet correctly.
MY15_BARINA SPARK_BOOK.indb 141 14/07/2014 12:00:47 PM
To Next Page
Loading...
