HOLDEN MJ BARINA SPARK 2015 - Engine coolant level and addition

144 Vehicle care
Engine oil
Checking oil level
• Check the engine oil level before
a long journey.
• The engine must be at operating
temperature and the ignition
turned off for at least 5 minutes.
1. Park the vehicle on a level
surface.
2. Remove the dipstick and
wipe clean.
3. Insert the dipstick rmly.
4. Remove and read the oil level.
The level should be at the MAX
mark. Add oil if the level is at the
MIN mark.
5. Insert the dipstick to the stop on
the handle and rotate half a turn.
Adding engine oil
See Capacities on page 192.
1. Rotate the engine oil ller cap
anticlockwise and remove.
2. Add enough oil to reach below
the MAX mark on the dipstick.
3. Check the level on the dipstick
and add further oil if necessary.
The engine oil must not exceed
the MAX mark on the dipstick.
Caution
Overlled engine oil must be
drained or suctioned out.
MY15_BARINA SPARK_BOOK.indb 144 14/07/2014 12:00:48 PM