Vehicle care 149
Checking brake/clutch
uid level
Check the brake uid level weekly.
The level should be between the
MIN and MAX area.
If the uid level is correct, do not
remove the reservoir cap, as brake
uid exposed to the atmosphere will
quickly absorb moisture.
Adding brake uid
See Recommended uids, lubricants
and parts on page 187.
1. Turn the ignition off.
2. Wipe the sides of the cap clean.
3. Rotate the brake/clutch uid
reservoir cap anticlockwise and
remove.
4. Top up with the recommended
brake uid.
Warning
Using brake uid other than GM
recommended brake uid may
cause corrosion to components
of the braking system and
reduced braking performance.
Use only new brake uid. Use of
old, used or inferior brake uid
may endanger the functioning of
the brake system.
5. Secure the cap and clean up any
spilt uid.
If the brake/clutch uid requires
regular topping up, contact a Holden
Dealer immediately.
Caution
Do not dispose of used brake
uid with household waste.
Use the local, authorised waste
management facility.
MY15_BARINA SPARK_BOOK.indb 149 14/07/2014 12:00:48 PM
To Next Page
Loading...
