152 Vehicle care
Headlamps
Front lamps are accessible from
within the engine compartment.
Low and high beam:
1. Detach the plug connector from
the bulb.
2. Remove the protective cover.
3. Press the spring clip to
disengage.
4. Remove the bulb from the
reector housing.
5. Fit the new bulb by engaging
the lugs in the recesses on the
reector.
6. Engage the spring clip.
7. Place the headlamp protective
cover into position and close.
8. Attach the plug connector onto
the bulb.
9. Check lamp operation.
Headlamp aiming
If the headlamps require adjustment,
contact a Holden Dealer.
MY15_BARINA SPARK_BOOK.indb 152 14/07/2014 12:00:49 PM
To Next Page
Loading...
