156 Vehicle care
Side turn signal lamps
1. Push the lamp holder towards
the rear of the vehicle and
remove.
2. Rotate the bulb holder
anticlockwise.
3. Pull the bulb out of the bulb
holder.
4. Insert a new bulb.
5. Place the bulb into the bulb
holder and rotate clockwise.
6. Replace the lamp holder.
7. Check lamp operation.
Number plate lamp
1. Unscrew the two screws.
2. Remove the bulb housing by
pulling downwards.
Do not to pull on the cable.
3. Rotate the bulb holder
anticlockwise to disengage.
4. Remove the bulb from the holder.
5. Insert a new bulb.
6. Insert the bulb holder into the bulb
housing and rotate clockwise.
7. Insert the bulb housing and
replace the two screws.
8. Check lamp operation.
Interior lamps
Courtesy lamps
1. Using a at-blade screwdriver,
prise the lamp assembly
outwards, from the side opposite
the lamp switch.
2. Remove the bulb.
3. Insert a new bulb.
4. Reinstall the lamp assembly
rmly into place.
5. Check lamp operation.
MY15_BARINA SPARK_BOOK.indb 156 14/07/2014 12:00:50 PM
To Next Page
Loading...
