172 Vehicle care
Warning
If the recommended pressure
cannot be reached after
approximately 10 minutes, the
vehicle should not be driven. The
tyre is too severely damaged
and the tyre sealant and air
compressor kit cannot inate the
tyre. Disconnect and stow the
tyre sealant and air compressor
kit back in its original position.
Contact a Holden Dealer.
20. Drain excess tyre pressure with
the button over the pressure
indicator.
Do not run the compressor
longer than 10 minutes.
21. Detach the tyre repair kit.
22. Push the catch on the bracket to
remove the sealant bottle from
the bracket.
23. Screw the tyre ination hose
to free the connection from the
sealant bottle. This prevents
sealant from escaping.
24. Stow the tyre sealant and air
compressor kit in the load
compartment.
Warning
Always stow the tyre sealant and
air compressor kit in its original
position. Unsecured loads
increase the risk of injury during
heavy braking, sudden avoidance
manoeuvres or a collision.
25. Remove any excess sealant
using a cloth.
26. After inating the tyre, remove
the maximum speed label and
place it in a visible location.
It reminds you to drive cautiously
and not to exceed 80 km/h until
the damaged tyre is replaced or
repaired.
27. Continue driving immediately so
that sealant is evenly distributed
within the tyre.
28. After driving approximately 10 km
(but no more than 10 minutes),
stop at a safe location to check
the tyre pressure.
29. Screw the compressor air hose
directly onto the tyre valve and
compressor to check the tyre
pressure.
30. If the tyre pressure is more than
1.3 bar, set it to the correct value
(approx. 2.2 bar).
MY15_BARINA SPARK_BOOK.indb 172 14/07/2014 12:00:53 PM
To Next Page
Loading...
