Vehicle care 173
31. Repeat the procedure from
Step 27 until there is no more
loss of pressure.
If the tyre pressure has fallen
below 1.3 bar, do not continue
driving. Contact a Holden Dealer.
32. Dispose of the used tyre sealant
canister at a Holden Dealer or in
accordance with local and State
codes and practices. Replace
with a new canister.
33. Stow the tyre sealant and
compressor kit in the load
compartment.
This is a temporary puncture repair.
Take the vehicle to a Holden Dealer
to have the tyre repaired or replaced
as soon as possible.
Tyre changing
The vehicle may have a spare tyre.
Warning
All passengers must be out of the
vehicle when it is being jacked.
Do not jack a vehicle with a trailer
attached. Remove the trailer rst.
Only jack the vehicle on hard,
level surfaces.
Ensure moving parts of the
jack are adequately lubricated
before use.
Use the jack only at the
designated lifting points. Use
in other locations may result in
the vehicle falling off the jack, or
damage to the vehicle.
Do not start or run the engine
while the vehicle is supported by
the jack.
Use the jack only for lifting the
vehicle when changing wheels.
Do not get under a vehicle that is
supported by a jack. No person
should place any portion of their
body under a vehicle that is
supported by a jack.
Vehicles with alloy wheels may
have a steel spare wheel. Drive
carefully and do not exceed
80 km/h if the tyre size or tread
pattern of the spare tyre is
different to the other tyres on
the vehicle. Although the spare
tyre was fully inated when the
vehicle was new, it can lose air
over time. Check the ination
pressure regularly.
After installing the spare tyre
on the vehicle, stop as soon as
possible to check the ination
pressure is correct. Have the at
tyre repaired or replaced and
installed back on the vehicle as
soon as possible.
MY15_BARINA SPARK_BOOK.indb 173 14/07/2014 12:00:53 PM
To Next Page
Loading...
