Vehicle care 175
11. Place the wheel wrench over the
wheel nuts and loosen by half
a turn, but do not remove the
wheel nuts.
12. Position the jack beneath the
jack location closest to the wheel
being changed.
The locations are identied by
cutouts in the underside of the
door sill.
13. Rotate the jack handle to raise
the head slightly.
14. Attach the jack handle to the jack
and attach the wheel wrench to
the jack handle.
15. Wind the jack up by hand until it
engages with the jacking point.
Ensure that the jack is not tilted
and the base is resting squarely
on the ground.
MY15_BARINA SPARK_BOOK.indb 175 14/07/2014 12:00:54 PM
To Next Page
Loading...
