Lighting 65
High/low beam
To activate high beam:
1. Turn the headlamps on.
2. Push the lever forwards.
The high beam indicator lamp
P illuminates on the instrument
cluster.
To return to low beam:
1. Pull the lever rearwards.
Warning
Always switch the headlamps
to low beam when vehicles are
approaching or when following
another vehicle.
To ash the high beam lamps:
1. Turn the ignition on.
2. Pull the lever towards the rear of
the vehicle and release.
The lamps stay on for as long as
the lever is held.
Automatic light control
The vehicle may have automatic
light control.
When the lamp control is in the
AUTO position, the headlamps are
automatically switched on and off
depending on lighting conditions.
• Do not cover the light sensor on
top of the instrument panel.
• The automatic light control turns
off when turned to
P
or the
ignition is off.
MY15_BARINA SPARK_BOOK.indb 65 14/07/2014 12:00:34 PM
To Next Page
Loading...
