156 Vehicle care
5. Remove the bulb socket from the
taillamp assembly by turning it
anticlockwise.
6. Remove the bulb from the socket
by pulling it straight out.
7. Install a new bulb into the bulb
socket.
8. Install the bulb socket into the
taillamp assembly by turning it
clockwise.
9. Install the taillamp assembly and
tighten the three screws.
10. Push the flocking back into place.
Light assembly in the boot lid
1. Open the boot lid.
2. Remove and retain the pushpins
securing the flocking. Pull back
the flocking to expose bulb
sockets.
3. Remove the bulb socket by
turning anticlockwise and pulling
straight out.
Tail light/Brake light/Turn-signal
light
1
Reverse light /Rear fog light
(depending on side) 2
4.
Remove the bulb from the socket
by pulling it straight out.
5.
Install the new bulb in the bulb
socket.
6. Install the bulb socket by turning
clockwise.
7. Push the flocking back into place
and secure with the retained
pushpins.
Side turn signal lights
1. Push light towards the front of the
vehicle and remove.
2. Rotate bulb holder anti-clockwise.
3. Pull bulb out of the bulb holder and
renew.
4. Reinstall in reverse order.
Number plate light
Number plate lights are designed as
LED. They are located in the boot lid
moulding and can not be changed.
Seek the assistance of a workshop in
case of defective LED.
Interior lights
Courtesy light, reading lights
Have bulbs replaced by a workshop.
To Next Page
Loading...
