162 Driving and operating
Rear Vision Camera
(RVC)
The rear vision camera (RVC)
system is designed to assist the
driver when reversing by displaying
a view of the area behind the
vehicle.
The RVC cannot display objects:
• Close to the corners of the
vehicle.
• Forward of the camera.
• Higher than the camera.
Note
• The distance of the objects seen
on the display differs from the
actual distance.
• The area displayed depends on
the road condition and vehicle
orientation.
Fault
If a fault occurs, r illuminates:
• Move the vehicle with care.
• Check and clean the sensors.
Notes on operation
• The alarm tones differ depending
on the objects detected.
• If the sensors receive other
ultrasonic signals e.g. metallic
sounds or exhaust brake noise
from heavy commercial vehicles,
the system may not work
properly.
• The system may not activate
if the sensors are frozen or
covered with dirt.
• Clean dirty sensors with a soft
sponge and clean water.
• Do not push or scratch the
surface of the sensors.
• Do not hit or direct high pressure
water directly at the sensors as
they may be damaged.
• The system may not recognise
sharp objects, thick clothes or
other materials which absorb
ultrasonic waves.
• The system may not operate
correctly when the vehicle is
driven over uneven surfaces.
To Next Page
Loading...
