Vehicle care 189
Low and high beam
1. Open the bonnet. Bonnet 0 178
2. Remove the headlamp bulb
cover by rotating anticlockwise.
3. Disconnect the wiring harness
connector from the bulb.
4. Turn the bulb anticlockwise
and pull straight back from the
headlamp.
5. Install a new bulb into the
headlamp and rotate clockwise.
6. Reconnect the wiring harness
connector.
7. Fit the headlamp bulb cover in
position and close by rotating
clockwise.
8. Check lamp operation.
To Next Page
Loading...
