192 Vehicle care
Type 2
4. Remove the desired bulb holder
by rotating anticlockwise.
5. Remove the bulb from the bulb
holder and replace the bulb.
6. Reinstall the bulb holder into the
tail lamp assembly by rotating
clockwise.
7. Install the tail lamp assembly,
tighten the screws and t the
screw covers.
5. Check operation of all lamps.
Number plate lamp
1. Using a at-blade screwdriver,
prise the lamp housing
downwards.
2. Remove the lamp housing by
pulling downwards.
Do not pull on the cable.
3. Rotate the bulb holder
anticlockwise to disengage.
4. Remove the bulb from the bulb
holder and replace the bulb.
5. Insert the bulb holder into
the lamp housing and rotate
clockwise.
6. Reinstall the lamp housing and
secure.
7. Check lamp operation.
To Next Page
Loading...
