Keys, doors and windows 19
With ignition switch
Use CR2032 battery or equivalent.
1. Open the cover.
2. Remove the used battery.
Avoid touching the circuit board
to other components.
3. Install the new battery.
Place the negative side (-) down
towards the base.
4. Close the cover.
5. Check the key operation.
Remote control synchronisation
After replacing the battery, unlock
the door with the key in the driver’s
door lock and turn the ignition switch
to the ON position.
The remote control is synchronised
when the ignition is switched on.
With electronic key system
Use a CR2032 battery or equivalent.
1. Press button on the side of the
transmitter to remove the key
blade.
2. Reinsert the key blade
approximately 5 mm and rotate
the key blade to remove the back
cover, as shown.
Note:
Take care that no parts fall out.
3. Carefully lift the battery up using
a at tool.
4. Remove the battery.
5. Insert the new battery, positive
side toward the back cover.
6. Replace the back cover. Ensure
it clips in place securely.
7. Check key operation.
Electronic key synchronisation
The electronic key synchronises
itself automatically during every
starting procedure.
To Next Page
Loading...
