Vehicle care 187
6. Connect one end of the RED
lead to the positive terminal of the
booster battery (1).
7. Connect the other end of the
RED lead to the positive terminal
of the discharged battery (2).
8. Connect the BLACK lead to the
negative terminal of the booster
battery (3).
9. Connect the other end of the
black lead to a vehicle grounding
point, such as the engine block
or an engine mounting bolt (4).
Connect as far away from the
discharged battery as possible
(at least 60 cm).
Note
Route the leads so that they
cannot catch on rotating parts
within the engine compartment.
10. Start the engine of the vehicle
providing the jump start and
allow to idle for at least 5
minutes.
11. Start the engine of the vehicle
with the at battery.
Start attempts should be made
for no longer than 15 seconds at
an interval of 1 minute.
12. Allow both engines to idle for
approximately 3 minutes with the
leads connected.
13. Switch on the headlamps and
the heated rear window of the
vehicle that received the jump
start.
14. Leave the engines running while
removing the BLACK negative
jumper lead rst, followed by the
RED positive jumper lead.
Note
While removing each clamp, do not
touch any other metal while the other
end remains attached.
To Next Page
Loading...
