HOLDEN MY18 TJ Trax - Page 146

144 Driving and operating
0. LOCK: The key can only be
inserted and removed from this
position.
1. Ignition Accessory: When the
key is in this position, the audio
system operates.
2. Ignition On: When the key is in
this position, the engine is ready to
start and all electrical systems are
active.
3. Engine Start: Turn the key to
this position and release when the
engine is running.
Caution
Do not leave the key in positions
1 or 2 for a long time, unless the
engine is running, otherwise the
vehicle’s battery will discharge.
Vehicles with electronic key
The electronic key must be inside
the vehicle.
Accessory power mode: press
the Engine Start/Stop button once
without operating the brake pedal.
The yellow LED in the button
illuminates. The steering wheel lock
is released and some electrical
functions are operable; the ignition
is off.
Ignition on power mode: press and
hold the Engine Start/Stop button for
6 seconds without operating brake
pedal.
The green LED in the button
illuminates. Control indicators
illuminate and most electrical
functions are operable.
Engine Start: depress the brake
pedal and press the Engine Start/
Stop button once. Release the
button after the starting procedure
begins.
Ignition Off: press the Engine Start/
Stop button briey in each mode
or when engine is running. Some
functions remain active until the
driver’s door is opened.
Emergency shut off during driving:
Press the Engine Start/Stop button
for longer than two seconds or press
twice briey within ve seconds
Steering wheel lock
The steering wheel lock activates
automatically when:
• the vehicle is stationary,
• the ignition has been switched
off, and
• the driver’s door is opened.