Driving and operating 153
7. Press the screwdriver into the
slot. The ignition key can if a
screwdriver is not available.
8. Move the shift lever to N.
9. Remove the screwdriver from the
slot.
10. Replace the cap.
11. Have the vehicle repaired by
a Holden Dealer as soon as
possible.
Release shift lever
Before shifting out of P:
1. Turn the ignition on.
2. Press the brake pedal to the oor.
If you cannot shift out of P with the
ignition on and the brake pedal
pressed:
3. Turn the ignition off.
4. Press and hold the brake pedal.
5. Pull up on the park brake lever.
6. Remove the cap on the centre
console with a thin object such
as a at-blade screwdriver.
Manual transmission
Select reverse gear while the vehicle
is stationary:
1. Press the clutch pedal to the oor.
2. Wait 3 seconds.
3. Pull the button of the front of the
shift lever up.
4. Move the shift lever to position R.
If the gear does not engage:
1. Return the shift lever to neutral.
2. Release the clutch pedal.
3. Push the clutch pedal again and
repeat gear selection.
To Next Page
Loading...
