EasyManua.ls Logo

HOLDEN MY18 TJ Trax - Temporary puncture repair

HOLDEN MY18 TJ Trax
242 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Vehicle care 203
Repairs damage up to 4 mm in
the tread area of the tyre.
Does not repair damage at the
tyre’s side wall, near the rim.
Take the vehicle to a Holden Dealer
to have the tyre repaired or replaced
as soon as possible.
Warning
Do not drive faster than 80 km/h.
Do not drive on the repaired tyre
for an extended time. Steering
and handling may be affected.
Note
If unusual noises are heard or
the compressor becomes hot,
turn the compressor off for at
least 30 minutes.
Check the expiry date on the tyre
sealant canister before use. The
tyre sealant canister must be
replaced before its expiry date.
The compressor and sealant
can be used from approximately
–30°C to 70°C.
Temporary puncture repair
1. Apply the park brake.
2. Place manual transmissions into
rst or reverse gear.
Place automatic transmissions
into position P.
3. Remove the tyre repair kit from
behind the cover in the load
compartment, on the driver’s
side.
4. Remove the compressor and
sealant bottle.
5. Remove the electrical connection
cable (1) and air hose (2) from
the underside of the compressor.

Table of Contents

Related product manuals