Holden Colorado Owner Manual (Australia-Localizing-Australia-12333014) -
2019 - crc draft - 3/1/18
Driving and Operating 195
Interruption of Power
Supply
If the power supply is interrupted,
the shift lever cannot be moved out
of position P and the ignition key
cannot be removed.
If the battery is discharged, start the
vehicle using jump leads. See Jump
Starting 0 260.
If the battery is not the cause of the
fault, release the shift lever and
remove the ignition key from the
ignition switch/lock.
Release Shift Lever
To shift out of P:
1. Apply the brake pedal.
2. Open the cover.
Note
Use a small screwdriver to prise the
cover off at both ends.
3. Insert a screwdriver into the
slot until the shift lever is
unlocked.
4. Move the shift lever to
position N.
5. Remove the screwdriver.
6. Close the cover.
7. Have the vehicle repaired by a
Holden Dealer as soon as
possible.
To Next Page
Loading...
