Holden Colorado Owner Manual (Australia-Localizing-Australia-12333014) -
2019 - crc draft - 3/1/18
206 Driving and Operating
.
For safety reasons, cruise
control cannot be activated until
the foot brake has been
operated once.
{
Warning
Do not use the cruise control
when road or driving conditions
require varying speeds.
A consistent speed isn't practical
in heavy, varying traffic or on
winding, slippery or rough roads.
The cruise control does not apply
the vehicle's brakes. Therefore
the vehicle may gain speed when
going down steep hills.
When climbing steep hills, the
vehicle may lose speed. You may
need to switch off cruise control
and use the accelerator pedal.
Setting Cruise Control
1. Press ON OFF.
I illuminates white.
2. Accelerate to the desired
speed (above 20 km/h).
3. Push the switch down to SET/-.
I illuminates green.
4. Take your foot off the
accelerator pedal.
Increasing Set Speed
.
Push the switch up to RES/+
and hold it or briefly push to
RES/+ repeatedly.
The vehicle will accelerate.
.
Alternatively accelerate to the
desired speed and store by
pushing the switch down to
SET/-.
Note
Vehicle speed can be increased by
depressing the accelerator pedal.
When the accelerator pedal is
released, the previously stored
speed is resumed.
Note
The cruise control will remain
activated while shifting gears with
manual transmission.
Decreasing Set Speed
1. Push the switch down to SET/-
and hold it or briefly push to
SET/- repeatedly.
The vehicle will decelerate.
2. Release the switch at the
desired speed.
Deactivation
.
Press CANCEL.
I illuminates white.
Alternatively, do one of the
following:
.
Reduce vehicle speed below
approximately 20 km/h.
.
Press the brake pedal.
.
Press the clutch pedal for more
than a few seconds (manual
transmission).
.
The TCS or the ESC operates.
To Next Page
Loading...
