HOLDEN MY19 RG Colorado - Tread Depth

Holden Colorado Owner Manual (Australia-Localizing-Australia-12333014) -
2019 - crc draft - 3/1/18
Vehicle Care 253
for the remainder of the ignition
cycle. A DIC warning message also
displays. The malfunction light and
DIC warning message come on at
each ignition cycle until the problem
is corrected. Some of the conditions
that can cause these to come
on are:
.
One of the road tyres has been
replaced with the spare tyre. The
spare tyre does not have a
TPMS sensor. The malfunction
light and DIC message should
go off after the road tyre is
replaced and the sensor
calibration process is performed
successfully. See "TPMS Sensor
Calibration Process" later in this
section.
.
The TPMS sensor calibration
process was not done or not
completed successfully after
rotating the tyres. The
malfunction light and the DIC
message should go off after
successfully completing the
sensor calibration process. See
"TPMS Sensor Calibration
Process" later in this section.
.
One or more TPMS sensors are
missing or damaged. The DIC
message and the malfunction
light should go off when the
TPMS sensors are installed and
the sensor calibration process is
performed successfully. See
your dealer for service.
.
Replacement tyres or wheels do
not match the original equipment
tyres or wheels. Tyres and
wheels other than those
recommended could prevent the
TPMS from functioning properly.
See Tread Depth 0 253.
.
Operating electronic devices or
being near facilities using radio
wave frequencies similar to the
TPMS could cause the TPMS
sensors to malfunction.
If the TPMS is not functioning
properly, it cannot detect or signal a
low tyre condition. See your dealer
for service if the TPMS malfunction
light and DIC message come on
and stay on.
TPMS Sensor Calibration
Process
Each TPMS sensor has a unique
identification code. The identification
code needs to be matched to a new
tyre/wheel position after rotating the
tyres or replacing one or more of the
TPMS sensors. The TPMS sensor
calibration process should also be
performed after replacing a spare
tyre with a road tyre containing the
TPMS sensor. The malfunction light
and the DIC message should go off
at the next ignition cycle. The
sensors are matched to the tyre/
wheel positions, using a TPMS
relearn tool, in the following order:
driver side front tyre, passenger
side front tyre, passenger side rear
tyre, and driver side rear. See your
dealer for service.
Tread Depth
Check tread depth at regular
intervals.