Holden Colorado Owner Manual (Australia-Localizing-Australia-12333014) -
2019 - crc draft - 3/1/18
58 Storage
After assembling the tonneau cover
set, follow the procedure below for
installing:
There are two different types of soft
tonneau cover with different
installation procedures.
Installation (Tonneau cover 1):
1. Slide the bow through the
tonneau bow support bracket.
2. Place the tonneau cover
roughly in position with the tags
positioned at the sides and rear
of the vehicle.
3. Push down along the front
edge of the cover until it is
secure.
4. Starting from the rear, use the
finger loops to pull the cover's
plastic strip over the slot
provided around the top edge
of the load area.
5. Push down with your hands to
smooth the rear strip into place
along the slot.
6. After the cover is attached at
the rear, fit along both sides
beginning at the front of the
vehicle.
7. Where a sports bar is fitted,
wrap the velcro strips around
the sports bar on each side
and attach.
Note
The cover may be tight to fit
when new.
Removal:
1. Using the finger loops
provided, remove the cover by
pulling the loops out and up.
2. From underneath the cover,
remove the bar on one side, by
pushing it towards the front of
the vehicle and tilting down.
To Next Page
Loading...
