Holden Colorado Owner Manual (Australia-Localizing-Australia-12333014) -
2019 - crc draft - 3/1/18
Storage 59
The other end of the bar will
follow.
3. For storage, fold the cover,
ensuring the plastic sides are
not bent.
4. Place in a secure location to
prevent damage to the cover.
Fitting the Tonneau Cover with
High Loads
1. Remove the bow if required.
2. Attach the front of the cover.
See Soft Tonneau Cover.
3. Lay the remainder of the cover
roughly in position.
4. Underneath the cover there is
a cord with attaching clips.
Working around the vehicle,
place the clips in the slot
provided.
5. To remove the cover, pull the
clips out and up.
Installation (Tonneau cover 2):
1. Place one side of the rear
cross member into the inner
side of the rail.
2. Place the other end of the rear
cross member into the rail.
Align the cross member ends
with the existing labels at the
top of the rail.
3. Repeat the procedure above
for installing the front cross
member.
Caution
Never use the tonneau cover
without the cross members.
It provides support for the stretch
cover when the vehicle is moving
and prevent water accumulation
on top of the cover.
Caution
Never put weight on the cross
members or on any point of the
tonneau cover.
To Next Page
Loading...
