Holden Colorado Owner Manual (Australia-Localizing-Australia-12333014) -
2019 - crc draft - 3/1/18
60 Storage
4. Stretch the tonneau cover on
the load compartment, fitting
the rear beam in to the side rail
support without locking it.
If you use the load
compartment with the tonneau
cover open, first roll up the
tonneau cover and then secure
with the straps.
5. Attach the flexible sides of the
tonneau cover in to the side rail
support.
6. Lock the tonneau cover
bearings to the rail bearings.
After that, apply downward
pressure with your hand until it
locks.
Caution
Make sure that both sides of the
tonneau cover are fastened to the
bearings and rail before locking,
in order to avoid damage.
Caution
Before closing the tailgate, make
sure the vehicle keys are not
inside of the load compartment.
In order to open the tonneau cover,
lower the tailgate and pull the
release lever on the underside of
the tonneau cover down.
Caution
When opening the cover, do not
move the lever to the side,
only down.
Caution
Lubricate the tonneau cover
locking pin monthly.
To Next Page
Loading...
